Connect Speakertrack 60 To Codec C40 - Cisco Quad Camera Camera Manual

Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents

Connect SpeakerTrack 60 to Codec C40

• Connect the video cables (HDMI).
Left camera: Connect between Connector 1 (HDMI input) on the
codec to the HDMI input of the left camera.
Right camera: Connect between Connector 2 (HDMI input) on the
codec to the HDMI input of the right camera.
• Connect the camera control cable (Ethernet) between the
codec's 2nd Ethernet port and the Network port (Ethernet) on the
SpeakerTrack 60.
• Connect the power adapter to the SpeakerTrack 60, and connect
to power.
• Connect other codec cables as described in
Telepresence Codec C40 installation
HDMI 1 HDMI 2
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction Physical interface
theCisco
guide.
RJ45
Power
(100-240 V
AC
Connecting to a codec Connecting to a codec
When using a SpeakerTrack 60 with a C Series codec, the
codec cannot be controlled with the TRC5 (Cisco Remote
Control). Instead, a Cisco TelePresence Touch 8 user interface
or an external control device must be used.
Right
Power
adapter
Always use the provided power
, 50/60 Hz) cable and adapter.
21
Factory reset Appendix
Left
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide