Connect Ptz-12 To Sx80 Codec - Cisco Quad Camera Camera Manual

Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents

Connect PTZ-12 to SX80 Codec

• Connect the video cable (HDMI) between the camera and codec.
Codec: Always use Connector 1 (HDMI input) for the main camera.
Camera: Connect to the HDMI output.
• Connect the camera control cable (Ethernet).
Connect between the codec's 2nd or 3rd Ethernet port to the
Network port (Ethernet) on the PTZ-12 connector panel.
• Connect the power adapter to the camera and connect to power.
• Connect other codec cables as described in
Telepresence SX80 installation guide.
RJ45
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction Physical interface
theCisco
HDMI
Connecting to a codec Connecting to a codec
Power
(100-240 V , 50/60 Hz)
AC
26
Factory reset
Power
adapter
Always use the provided power cable
and adapter.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide
Appendix