SOLIS GRIND & INFUSE COMPACT User Manual page 78

SPEC I A L N OTE S O N THE USE OF P ODS
■
If you want to use pods for making your espresso, place them in the centre of the
filter insert for pods (R). Make sure that all of the pod paper is in the filter insert
and that no paper protrudes over the edge of the filter insert. Please follow the
instructions on the pods packaging. Turn the filter insert into the brewing head as
described above.
CAUTION: If the pod is not placed in the centre of the filter insert, the portafilter
cannot be completely screwed into the brewing head and a few drops of hot water
may drip from the portafilter.
GB
If you unscrew the portafilter from the brewing head after the coffee has been
extracted, the pod may stick to the brewing head. To remove it from there, tilt the
portafilter slightly and tap the pod to release it so that it falls into the portafilter.
6 . R E MOVI N G TH E FIL TER INSER T F ROM T H E PORT AF IL T E R
When the portafilter with the filter insert has cooled down slightly, you can re-
●
move the filter insert using a teaspoon handle. Slide the handle underneath the
filter edge and lever the filter insert out of the portafilter.
7. PRE P A RE M OR E ES PRES SI
Your Solis Grind & Infuse Compact espresso machine is equipped with an electronic
system that allows you to brew several espressi in a row, always ensuring the per-
fect brewing temperature. If you press the corresponding button (
respective function light flashes until the appliance has cooled down again. As soon
as the function light is constantly illuminated, the espresso is extracted.
E N E R GY - SAV IN G FUNC TION: AUT OMAT IC SHU T DO WN
■
Your Solis Grind & Infuse Compact espresso machine is equipped with an auto-
matic shutdown to save energy. This switches the machine off automatically if it is
not used for approx. 30 minutes. If you want to put the appliance back into opera-
tion, press the On/Off button and wait until all four function lights of the buttons
;
( and , , ) light up constantly again.
154
WAT ER TA N K R UNS EMPTY DUR IN G USE
■
Always check the water level in the water tank and fill the water tank daily. When
●
the tank runs empty, your appliance vibrates and the operating noise becomes
noticeably louder. The four function lights of the buttons (
flash.
In this case, switch off the appliance with the On/Off button and discon-
●
nect the power plug. Remove the portafilter from the brewing group.
Fill the tank with fresh, cold tap water up to the MAX marking and recon-
nect the power plug. Switch the appliance on again with the On/Off but-
ton. Check that the steam / hot water control is in the central position
Wait until the function lights of the four buttons (
light up constantly again and the appliance has reached its operating temperature.
Place the milk jug under the steam/hot water wand.
●
Turn the steam/hot water control to the right, to the hot water function
●
The steam/hot water function light illuminates constantly. Leave the hot water
●
function switched on until the circuit has filled up with water and the hot water
runs normally out of the steam/hot water wand.
Then, turn the steam/hot water control back to the central position
●
function lights (
or ), the
The appliance can be put back to normal use.
●
;
and , , ) are still flashing, please repeat this process.
;
and , , )
GB

.
;
and , , )
.

. If the four
155