Table of Contents
Advertisement
1. Installing the Software
1-2. Install the USB-MIDI Driver
1-2-1
Turn on the DME unit and connect it to your computer using a USB
cable. When the message "Installing device driver software" appears in
the taskbar at the bottom right of the screen, install the driver manually.
1-2-2
"Found New Hardware"
window appears. Select
[Locate and install driver
software (recommended)].
1-2-3
Select [I don't have the
disc. Show me other
options.].
1-2-4
Select [Browse my
computer for driver software
(advanced).].
1-2-5
Click the[Browse]button.
Locate the downloaded
and extracted "Driver"
folder and click [OK].Click
[Next] to start the
installation process.
2. Basic Setup
3. Advanced Setup
(via USB cable)
4. In-depth information
(via Ethernet cables)
1-2-6
Click the[Install]button.
1-2-7
Installing driver software.
1-2-8
A message will appear
when installation has
finished. Click [Close] to
complete the driver
installation process.
1-2-9
The procedure and screen which were described here are a case of
WindowsVista. When Windows 2000 or Windows XP is used, please set
up similarly according to directions of a screen.
For the latest information about DME Designer System Requirements, visit the
Yamaha Pro Audio website:
http://www.yamahaproaudio.com/
Troubleshooting & Tips
Precaution regarding USB ports and driver installation
On computers featuring multiple USB ports, drivers are installed individu-
ally for each port. After installation, therefore, if connection is made via a
port other than that originally used, it will be necessary to install the driver
once again. To avoid this, either set a dedicated port for DME connection
in advance or install the driver on all of your computer's ports.
It is also important to note that USB drivers differ depending on the model
of DME used. Although the same driver can be used for multiple DME
units of the same model, different models – such as the DME64N and
DME24N – require different USB drivers. (To be exact, the USB drivers
themselves are identical, but the INF files used upon installation differ.)
Avoid USB hubs
As is often the case with digital mixers, your computer may not recognize
the DME unit if connected via a USB hub. In principle, therefore, connec-
tion should be made directly to one of your computer's built-in USB ports.
03
on DME Units
DME-N Network Driver Settings
Appendix: Detailed
Advertisement
Table of Contents
