Configuring Components - Yamaha DME Series Setup Manual

1. Installing the Software
2-2. Setting up DME cards
The following settings are required only when expansion cards will be
used with the DME24N, or DME64N. If this is not the case, proceed to
Step (2-3) below.
With the expansion card
already inserted into the DME
unit, right-click on the
corresponding DME icon and
select [Properties...] from the
bottom of the menu displayed.
Right-click
2-3.

Configuring components

First of all, double-click the icon for your DME unit to
display the Configuration window.
Drag and drop the components that you require into the configuration
area from the list on the left-hand side.
2. Basic Setup 3. Advanced Setup
(via USB cable)
In the DME Device Properties
window that is displayed, select
the currently-inserted
expansion card as shown below
and click the [OK] button.
Double-click
Drag and drop
4. In-depth information
(via Ethernet cables)
Click k
* Components can also be freely dragged around the configuration area using the mouse.
To remove a component or an incorrectly connected wire, click the component or wire,
confirm that it turns red, and then press the [Delete] button on the computer keyboard.
When you have setup all connections in the same way as shown below,
its time to write the configuration to the DME unit.
05
on DME Units DME-N Network Driver Settings
To connect components, click the
required input or output port and
drag the end of the connecting
wire to the required destination.
Click
Appendix: Detailed