Tool Operation; Mode Selection - Senco FUSION F-35XP Operating Instructions Manual

loading THe Tool:
Insert strip of nails into rear of magazine.
• Use only genuine SENCO fasteners (see Fastener Specifications).
• Do not load with workpiece contact (safety element) or trigger depressed.
Pull feeder shoe back.
Unloading THe Tool:
Push Button on feeder shoe to release feeder from strip. Pull fastener strip out past sheet metal nail detainer.

Tool operation

Read section titled "Safety Warnings," before using tool.
For best results, charge new battery before using. (see "To Charge Battery" on page 17).
Indicator LED
ON-Flashing
All Fusion tools are equipped with selective-actuation triggering. This allows the user to choose between the
following modes of operation:
Indicator LED
ON-Flashing
Indicator LED
ON-Solid
Tool oPeraTion
The tool should be switched off when not in use. Hold down either side of the selector
switch for 1 second to turn the tool off. If left on, the tool will automatically turn off
after 20 minutes.
Contact actuation
Pressing the side of the selector switch toward the T T T symbol (as shown) for 0.5
sec. will turn the tool on in contact-actuation mode. This is indicated by the flashing
green LED of the selector switch.
sequential
Pressing the side of the selector switch toward the T symbol (as shown) for 0.5 sec.
will turn the tool on in sequential mode. This is indicated by the solid green LED of the
selector switch.
12