Advertisement
Available languages
Available languages
================================================================================================
1.
Install Drawbar (3) to the Tray (5) using two 5/16" X
1" Round Head Screws (11), two 5/16" Lock Washers
(13), and two 5/16" Hex Nuts (12) as shown in Figure
1.
2.
Assemble the Clevis Drawbar (20) to the Drawbar (3)
using two 5/16" X 1" Round Head Screws (11), two
5/16" Lock Washers (13), and two 5/16" Hex Nuts
(12). See Figure 1.
NOTE: Install Clevis (20) in direction shown.
3.
Install the two End Panels (1) to the Tray (5) using six
5/16" X 3/4" Round Head Screws (10), six 5/16" Flat
Washers (14), six 5/16" Lock Washers (13), and six
5/16" Hex Nuts (12). See Figure 2.
NOTE: Leave nuts loose in this step so that the
End Panels can be adjusted later.
4.
Fasten an E Ring (19) onto the Tine Shaft (2) and
place a 5/8" Flat Washer (15) onto the Tine Shaft,
see Figure 3. Push the shaft through one End Panel
(1).
5.
Place a Square Bearing (17) and then a 5/8" Flat
Washer (15) onto the Tine Shaft, see Figure 3.
4.
1008590BH-E
ASSEMBLY
Figure 1
12
Figure 2
12
1
13
14
10
Figure 3
19
15
17
15
1
12
3
13
13
20
11
11
5
2
5
12
13
14
12
13
1
14
10
Advertisement
