Table of Contents
Advertisement
CNX i3000
Calibration Manual
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user. A
Caution identifies conditions and procedures that can cause damage to the Product or the
equipment under test.
To prevent possible electrical shock, fire, or personal injury:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
2
riešenia na presné meranie
Carefully read all instructions.
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
Limit operation to the specified measurement category,
voltage, or amperage ratings.
Do not touch voltages > 30 V ac rms, 42 V ac peak, or 60 V
dc.
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
Do not use, and disable the Product if it is damaged.
Do not use the Product if it operates incorrectly.
The battery door must be closed and locked before you
operate the Product.
Replace the batteries when the low battery indicator shows
to prevent incorrect measurements.
Have an approved technician repair the Product.
Use only specified replacement parts.
Comply with local and national safety codes. Use personal
protective equipment (approved rubber gloves, face
protection, and flame-resistant clothes) to prevent shock
and arc blast injury where hazardous live conductors are
exposed.
Do not work alone.
Before each use, examine the Product. Look for cracks or
missing pieces of the clamp housing or output cable
insulation. Also look for loose or weakened components.
Carefully examine the insulation around the jaws.
De-energize the circuit or wear personal protective
equipment in compliance with local requirements before
you apply or remove the Flexible Current Probe.
Do not operate the Product with covers removed or the case
open. Hazardous voltage exposure is possible.
Remove the input signals before you clean the Product.
Warning
http://www.elso.sk
Advertisement
Table of Contents
