Motorola MBP36S Manual page 7

Why is the talk back feature not working?
Increase the volume on the Parent Unit.
Check that you have released the button after speaking to hear the response. The button is pressed
only when you are speaking.
The parent and baby unit may be out of range. Reduce the distance between the two.
Verify that the connections on the Baby Unit and at the electrical outlet are secure.
Lift the antenna on the Parent Unit for optimal reception.
Connection issues
What should I do if the Baby Unit has lost its connection with the Parent Unit?
Try recharging or press the Reset button once on the Parent Unit
If the Baby Unit is too far away it may be going out of range, so move the Baby Unit closer to the
Parent Unit.
Is the Unit turned on? Press and hold the ON/OFF button on the Parent Unit to turn it ON.
Is the correct Camera selected? Change the Camera number, if necessary.
Is the video display turned on? Press the VIDEO ON/OFF button to turn it ON.
When operating using batteries only, the display will go blank after 4 minutes to save power. The
unit is still active and will give you audio alerts. You can reactivate the screen by pressing any button.
To Reset the Parent Unit, press the reset button, disconnect the battery pack on the Parent Unit
and unplug both the Units' electrical power, then plug them back in. Wait about 15 seconds before
reconnecting. Allow up to one minute for the Baby Unit and the Parent Unit to synchronise
My display shows "No Signal" even though both units are connected and powered on. What do I
do?
They are no longer paired and require re-registration. Select "add" at the camera menu screen on
the display. Select a camera, 1, 2, 3, or 4. An LED on the display will blink and the display will show
"press pair on cam". On the bottom of the camera unit, press the pair button. A confirmation
beep will sound.