Preventive Maintenance - BodyCraft Spacewalker LT100 Owner's Manual

Hide thumbs Also See for Spacewalker LT100:
Table of Contents

Advertisement

PREVENTIVE MAINTENANCE

Preventive Maintenance is the responsibility of the owner and not covered under warranty.
To maximize the life of your treadmill, and minimize downtime, all BODYCRAFT equipment requires
regular cleaning and maintenance performed on a scheduled basis. Always unplug the power cord from
the wall before servicing near potential moving parts or under the hood. ONLY qualified service
professionals or BODYCRAFT dealers should remove the motor hood.
Daily Maintenance Items
● Clean entire machine using water and mild detergent such as "Simple -Green" (cleaning agents
should be alcohol and ammonia free), including console, handlebar / grip area and running belt.
● Check Emergency Stop Key and tether cord for proper operation.
Monthly Maintenance Items
● Vacuum under treadmill and wipe off all dirt around rollers & belt/deck
areas.
● Inspect power cord for damage, inspect hand grip areas. and inspect
the Emergency Stop tether cord.
● Check running belt for proper tension; adjust if needed. It is especially
important to check the running belt for tension after the first 30 days of
usage. All new belts will stretch, and belt slippage can be detected by
users if the running belt does not have the proper tension.
Annual Maintenance Items
● Unplug the power cord from the wall, inspect the underside of running belt for damage, and checking
for cracking or glazed surface.
● If the belt has damage or wear to it that warrants replacement, please note that the running deck
must also be flipped when a new belt is installed. If the deck has previously been flipped and no
longer has an unused side available, it needs to be replaced when the new belt is installed.
(Example of changing oil and rotating tires on new car.)
● Unplug the power cord from the
wall, clean between belt and deck
with a large towel, then lube with
BODYCRAFT deck lube. Walk-in
lube for 1 min, then run belt at 4
mph for 2 mins.
● During normal operating conditions,
the running belt and deck
replacement should be done every
20,000 miles.
15

Advertisement

Table of Contents
loading

Table of Contents