Basic Instructions; Quick Test - Raytech WR50-12 Preliminary Instruction Manual

BASIC INSTRUCTION:
WARNINGS!
BEFORE OPERATING THIS OR ANY OTHER TEST EQUIPMENT READ ALL SAFETY
WARNINGS AND UNDERSTAND THEM FULLY.
WARNINGS!
BEFORE USING THE BASIC OPERATING INSTRUCTIONS THE OPERATOR SHOULD
BE COMPLETELY FAMILIAR WITH THE TEST SYSTEM AND THIS TYPE OF
TESTING.

QUICK TEST:

This section outlines the basic measurement instruction, step by step, for the WR50-12.
These are basic instructions, simplified, for the trained and qualified operator.
1. Connect the test leads (2 Current / 2 or 4 Potential) to an un-energized device to be
measured.
2. Connect the Safety Ground on the front panel to known good Earth Ground.
3. Turn on the Test system.
4. Select the Current Range.
5. Select (Touch) "Start" to start the test.
6. When results are displayed and are stable press "Store".
7. To end the test press "Stop".
8. Wait for "Safe" Status display.
Raytech USA, Inc. All rights reserved. No portion may be reproduced without written consent.
10 – 0
10 – 1
22