Data Transmission; Data Transparent Transmission - Ebyte E104-BT52 User Manual

Configure module according to 6.4 command table.


7.2 Data transmission

For data transmission related instructions, see 5.3 Data Transmission Mode.

Test Conditions:
Configure one module as the master and one as the slave as described in the quick use guide for AT command

list configuration mode;
Software: AccessPort.

Other parameters are the default configuration.


7.2.1 Data transparent transmission

1. Power on the module. Enable logmsg printing for master and slave (at+logmsg=1);
2. Set the module to transparent transmission mode (AT+TRANMD=1).
3. After the host is successfully connected, it will print "sta: connecte 0 616263646564"; the slave will print sta: connecte 0
616263646566". The LINK pin is high. As shown below, the host is automatically connected and printed: The slave is powered on The
automatic connection printing is shown in the figure. The value before the MAC address in the host print information is the slave
handle in the host, and the first byte of the format transmission comes from this.
Copyright ©2012–2020，Chengdu Ebyte Electronic Technology Co.,Ltd
Over air configuration authentication
27