At+Ipwr Revise Ibeacn Tx_Power; At+Name Advertising Device Name; At+ Conintv Connection Interval Configuration - Ebyte E104-BT52 User Manual

6.4.17 AT+IPWR revise ibeacn tx_power

Command
Inquiry AT+IPWR?
Set AT+ IPWR =[para]
para(HEX)： 0-0XFF
Parameter
default：0
1. Take effect immediately (if the broadcast is not turned on, or it is connected, it will take effect next time),
Note save when power off;
2. Only the slave device supports broadcasting, other roles can still be configured;

6.4.18 AT+NAME advertising device name

Command
Inquiry AT+NAME?
Set AT+NAME=[para]
Set
AT+NAME1=[para]
（Do not save）
para(HEX): advertising device name,
Parameter
advertising name is not more than 22 bytes
default：E104-BT52-V1.0
1. Take effect immediately, save when power off;
Note
2. Only supported by the slave, other roles can still be configured;

6.4.19 AT+ CONINTV connection interval configuration

Command
Inquiry AT+CONINTV?
Set AT+CONINTV =[para]
[para]（ASCII) : connection interval，value range，10~2500；
Parameter
Default：20ms
Note
Take effect immediately, save when power off.
1. The connection timeout must be greater than the connection gap;
Note 2. The device with incorrect parameters will not receive and save.
3. It is not recommended to modify the host connection gap.
AT+CONINTV=20
For example,
Connection interval 20ms
Copyright ©2012–2020，Chengdu Ebyte Electronic Technology Co.,Ltd
Response
+OK=[para]
+OK：success
+ERR=[NUM]：error
Response
+OK=[para]
+OK：success
+ERR=[NUM]：error
Response
+OK=[ para]
+OK：success
+ERR=[NUM]：error
16