Advertisement
Mounting the lamp in suspended ceiling.
Set up the lamp to the suspended ceiling as it is shown bellow (Required opening 110mm):
Step 1
Bend the springs, to get into the hole of the suspended ceiling, as you can see to the next figure.
Step 2
Push up the luminaire, as shown in figure 2.
Step 3
Continue to push upwards until the lamp locks.
Install the luminaire according to the following
Step 1. Follow the step 1 of the installation instructions.
Step 2. Unfasten the retaining screw (Figure 4) and detach the part for suspended ceiling installation.
Step 3.
Drill 2 holes on the base
pass. Mark these two drilled points on the required mounting location, drill the holes and install
the supplied plastic plugs.
installation on the ceiling you must align the base with the indications on the luminaire's base.
Step 4. Install the decorative rim (package included).
require location.
Step 5. Follow the steps 2,3 and 4 of the installation instructions.
Retaining fastener
Page 3 from 4
Figure 1
Figure 2
Figure 3
If you want to pull off the device, put a flat blade
screwdriver, between the device and the ceiling.
Surface mounting
steps:
(Figure )
5 using a 4mm drill bit in order to permit the retaining screws to
ATTENTION!! Especially for the GR-270 and GR-272 luminaire
Figure 4
Next, use the 2 fasteners to install the unit to the
Drill here
Figure 5
Ø110mm
Indications
923270000_09_004
Advertisement
