TechniSat DIGITRADIO 301 IR Instruction Manual page 6

8. Never unplug your unit by pulling on the power cord. Always grasp the plug firmly and pull straight out
from the outlet.
9. Repair or replace all electric service cords that have become frayed or otherwise damaged
immediately. Do not use a cord that shows cracks or abrasion damage along its length, the plug, or the
connector end.
10. To prevent fire or shock hazard, do not use this plug with an extension cord or other outlet unless the
blades can be fully inserted to prevent blade exposure.
11. During lightning or raining days, unplug the unit for additional protection during thunderstorms or when
the unit is not used for prolonged periods. This will prevent damage to the unit from lightning and power
surges.
12. Do not attempt to carry out any service work yourself. By opening or removing the cabinet, you may
be exposed to dangerous voltage or other hazards. Any service work should be carried out by qualified
technicians.
13. The normal function of the product may be disturbed by strong Electro-Magnetic Interference. If so,
simply reset the product to resume normal operation by following the instruction manual. In case the
function could not resume, please use the product in other location.
14. The means of disconnecting this apparatus from the mains supply is plug of adaptor. The disconnect
device shall remain readily operable.
15. In the interests of safety and to avoid unnecessary energy consumption, never leave the unit switched
on while unattended for long periods of time, e.g. overnight, while on holiday or while out of the house.
Switch it off and disconnect the mains plug from the mains socket.
10
3 Getting Started
Carefully remove your radio from the box. You may wish to store the packaging for future use.
What you can find inside of your package
> Main unit
> Power adapter
> Instruction manual
Positioning your Radio
Place your radio on a flat / stable surface that is not subject to vibrations.
Avoid the following locations:
> Where the unit will be exposed to direct sunlight.
> Where the unit will be close to heat radiating sources.
> Where the humidity is high and ventilation is poor.
> Where it is dusty.
> Where it is damp or there is a possibility of water dripping or splashing onto unit.
Adjusting the Antenna
Extend the antenna to ensure you receive the best reception possible in both DAB and FM radio modes. It may
be necessary to adjust the position of the radio and /or antenna to achieve the best signal.
Turning the Unit On/Off
Connect the plug at the end of power adaptor cable to the DC IN socket at the rear of unit. Then insert the
power adaptor into the mains socket. For initial use the unit will switch on.
Press the VOLUME/ knob to switch unit standby.
To turn off unit completely, unplug the power adapter from the mains socket.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
11