For Unit Valve - Kurt 3600V Series Operating Instructions Manual

3 to 6 months
1. Open vise to maximum opening.
2. Loosen and remove the movable jaw.
3. Remove spiral-retaining ring from handle end of the vise screw.
4. Remove the screw support from the vise body.
5. Remove the two-piece locking collar by removing the four SHCS.
6. With one screw still half way out spin off the first collar.
7. Using a pin or screw reach into the second collar and spin it off
exposing the bearings.
8. Remove the thrust bearing assembly consisting of (2) thrust
washers and (1) thrust bearing from the counter bore in the end of
the body.
9. Clean and inspect the counter bore, thrust washers and thrust
bearing.
10. Apply water resistant grease to the thrust washer (i.e. Kurt lube p/n
KLA or marine grade grease)
11. Install thrust bearing assembly on the screw in the reverse manner.
12. Install the first collar by spinning on the screw until it stops.
(Items 12-14 — See Fig. 6)
13. Install the second collar behind the first and spin on until it stops.
At this point the screw holes may or may not be lined up.
14. Turn the second collar counterclockwise until a hole lines up.
15. Then turn the collar back TWO (2) more screw holes. This will allow
proper distance for the collar to lock on the threads and keep the
bearings firmly in place. (Items 15-16 — See Fig. 7)
16. Install the four SHCS and make tight.
17. Install the screw support in the body on the screw (Hex end).
18. Your vise is now ready to use.
18 ENGLISH |
Maintenance Schedule