auna Stockton Manual page 38

EN
38
Dynamic Range Control (DRC)
DRC can make quieter sounds easier to hear when the unit is used in a noisy
environment. The DRC level of a broadcast is set by the broadcaster and
transmitted with the service. Changing the DRC value on your unit enables
you to apply a scaling factor to this level.
There are three levels of compression:
Maximum compression as sent with the transmitted
DRC high:
service.
Set to 1/2 that of the sent transmitted service.
DRC low:
No compression.
DRC off:
1. Press the MENU button to access the menu control.
2. Turn and press the Select dial or use the TUNE
on the remote control until "DRC" is displayed and then press the
SELECT button.
3. Turn and press the Select dial or use the TUNE
on the remote control to select the DRC value and then press the
SELECT button to confirm.
4. Press the MENU button to exit the menu control.
NOTE: Not all DAB broadcasts are able to use DRC function. If the
broadcast does not support DRC then the DRC setting in the unit will have
no effect. After you have adjusted the DRC level the sound may be louder.
Prune
This function removes inactive stations.
1. Press MENU button to access the menu control.
2. Turn and press the Select dial or use the TUNE
on the remote control to until "<Prune>" is displayed and then press the
SELECT button.
3. Turn and press the Select dial or use the TUNE
on the remote control to select "<Yes>" and then press the SELECT
button to prune the unit.
4. Press the MENU button to exit the menu control.
or TUNE button
or TUNE button
or TUNE button
or TUNE button