Operating Functions - Klarstein Gusteau Manual

EN
54

OPERATING FUNCTIONS

Setting the clock
• Under standby status, touch the clock button (K2) one time to enter clock
adjustment state.
• At this time hour value of the clock will flash (1 time/second). By rotating the
programming switch (KB2) you can set the hour time (0 – 23 is adjustable). While
you are setting the current hour, "h" is displayed on the screen.
Hour adjustment display effect
• After adjusting the hour time, touch the clock button (K2) again to switch to minute
adjustment.
• Minute value will flash at this time. By rotating the programming switch (KB2) you
can set the minute time (0 – 59 is adjustable). While you are setting the current
minute, "min" is displayed on the screen.
• After well set the minutes, retouch the clock button (K2) and the clock setting is
accomplished. At this time, the second icon ":" flashes. After confirmation, hour icon
and minute icon (h/min) are not shown on the screen anymore.
• If the clock setting is not confirmed within 10 seconds, the system defaults to
complete the clock setting and automatically returns to standby mode.
• If the clock is not set within 20 seconds after power on, the system defaults to 12:00
and enters standby mode. If the power is off, the clock will be reset.
• There will be only system clock displayed under standby status.
Function selection: operating modes
• Under standby status, switch different functions by rotating the programming switch
(KB1), refer to the picture below for the corresponding position icon (oven function
will remember the last operation).
• When selecting the function, the clock position shows the default cooking time of
the corresponding function (it will show "Eco" under Eco mode), the temperature
position shows the default temperature of the corresponding function.
Minute adjustment display effect
Function mode diagram