Personnel Qualifications And Safety - Emerson Roxar User Manual

Mechanical retrieval tool
Table of Contents

Advertisement

User Manual
ROX000295904
1.5

Personnel qualifications and safety

Read and follow all instructions, dangers, warnings, and cautions to avoid personal injury
or property damage during system operation. Emerson is not responsible for damage or
injury resulting from unsafe use of products, lack of maintenance, incorrect installation of
equipment or system operation. If in doubt about any applications and safety precautions
described in this document, contact Emerson.
Only personnel with necessary training and certification should operate the mechanical
retrieval tool on pressurized lines. Emerson recommends two skilled and trained operators
to perform the retrieval task. At least one of the operators must be certified for the task
and experienced. At a minimum, the other operator needs to have attended and passed a
theoretical and practical training course for retrieval operators. For further questions
about training requirements, contact your local Emerson representative.
Operations risk assessment must be used and followed in conjunction with this document
when performing all online retrieval operations.
Ensure that all end user and installation specific safety requirements are read, understood
and adhered to.
Ensure that any operator that is conducting work on the equipment, is following end user
guidelines on the use of protective equipment including, but not limited to:
Safety helmet or hard hat
Steel-toed shoes
Safety glasses
Working gloves (suitable for mechanical operations)
Chemical resistant latex gloves or the equivalent
Long-sleeved, fire-retardant shirt and fire-retardant trousers or full-length fire
retardant coveralls
Additional PPE may be required depending on facility requirements and MSDS
requirements, if applicable. Failure to do so may result in personnel injury.
NOTICE
Do not attempt to use any retrieval equipment unless you have been properly trained and
deemed competent in its safe operation.
All retrieval equipment must be inspected, and pressure tested prior to use as described in
the operating instructions (refer to
NOTICE
Observe all precautionary signs posted on the equipment to avoid serious injury.
WARNING
Risk to Personnel and Equipment: Operation of the Roxar Mechanical Retrieval Tool on
pressurized lines may potentially imply operational risk for personnel and equipment
from the potential escape of hot gas or liquid, which could result in serious injury.
Observe all precautionary signs on the equipment.
www.Emerson.com/Roxar
Operating
instructions).
Introduction
June 2020
7

Advertisement

Table of Contents
loading

Table of Contents