Section Iv. Printer Operation; Set-Up And Interpreting Readouts - Unitek MICROPULL IV MP4/115 Operation And Maintenance Manual

Set-up and Interpreting Readouts

NOTES:
x Throughout this manual the convention < > means "the computer key labeled." For example, <4>
means the key labeled 4. <Enter> means the key labeled Enter (or Return).
x For the following operations to work, as shown, the following conditions must exist:
The computer printer must be on line,
The computer RS-232 port must be connected to the MP4 RS-232 port (J1), and
The MP4 PRINTER/CMPTR switch must be in the CMPTR (computer) position (in).
1 Set the POWER switch on the MP4 to ON. Use the computer's keyboard to type MP4EXE, MP4BAS,
or MP4GW followed by <Enter> to run the MP4 program. The Title Screen appears momentarily.
2 To change an entry on either of the next two screens, use the <F9> key to indicate that you wish to make
a change. In those cases where only two answers are possible, the selection will automatically toggle.
Use the <Enter> key to terminate changes on those entries which do not toggle. On some keyboards, the
cursor keys will move the cursor within the entry. Other keyboards require that the <4> and <6> keys be
used. The <Backspace> key should perform its intended function. <Enter>, <8>, or the <2> keys will
step the pointer from line-to-line. The cursor keys will also perform this function on some keyboards. To
signify that no further changes are desired, press <Fl0>.
FIELD
Date
> Communications Port
DESTRUCT or NON-DESTRUCT Test (D/N)
Beam Size 10, 100, 1000 or 2000gf
Unit of Measure
Non-Destruct Pull - Min.= 0.9
Non-Destruct Max. -
Print All Data (Y/N)
Accept Failure Location Codes (Y/N)
Load Histogram History File (Y/N)
Use cursor keys to move, <F9> to change, and <F10> to exit
990-180

Section IV. Printer Operation

Define Hardware
®
MICROPULL IV WIRE BOND PULL TESTER
CHAPTER 3: OPERATING INSTRUCTIONS
CONTENTS
12-06-87
COM 1
N
100
gf
2.5
2.7
Y
N
N
3-9