Setup Controls; B100R Rotatable Beam And Hook Assemblies - Unitek MICROPULL IV MP4/115 Operation And Maintenance Manual

6 Rotate the knob while installing so
that the legs slip through the slot in
the bracket and fall into alignment
with the "T" handle. When the
knob is fully seated, insert retaining
clip into the shaft groove to capture
the knob assembly.
7 Turn the adjustment screw in the
knob to obtain clearance as shown
in figure 3-3. This will prevent the
"T" handle from flying off during
operation.
8 To remove the rotatable hook
assembly, reverse the above
procedure.

Setup Controls

1 Set or adjust the controls on the
Electronic Control Unit (figure 1-6, 1-7) as follows:
Control
POWER switch
ILLUMINATION control
PRESET FORCE thumb wheels
MODE switch
HOOK RETURN switch
UPSTOP control
BEAM TRAVEL control
DOWNSTOP control
* ZERO switch
* PULL RATE control
* HOLD TIME control
* UNITS switch
* PRINTER/CMPTR switch
* located on Rear Panel
990-180
4-29967-01
Rotatable hook
®
MICROPULL IV WIRE BOND PULL TESTER
CHAPTER 3: OPERATING INSTRUCTIONS
"T" handle
Beam arm
Figure 3-3. B100R Rotatable Beam and Hook
Setting
ON
As desired
2 - 10 gf beam
20 - 100 gf beam
200 - 1000 gf beam
NON-DESTRUCT
MANUAL
10.0 (fully CW to UP)
MIN (fully CCW)
DOWN (fully CCW)
MAN (out)
MAX (fully CCW)
MIN (fully CCW)
gmf (in)
PRINTER (out)
"T" handle
installation tool
270-019
Assemblies
Knob
4-30059-01
Beam bracket
Retainer clip
570-112
3-3