Unitek MICROPULL IV MP4/115 Operation And Maintenance Manual page 27

ECHO OFF CLS
PATH \DOS;\BASIC;\MP4;\LOTUS
CD\MP4
BASICA MP4 -or- GWBASIC MP4
For those users who elect to use the compiled version, MP4.EXE, a batch file, MP4EXE.BAT, has been
created which contains the following instructions:
ECHO OFF
CLS
PATH \DOS;\BASIC;\MP4;\LOTUS
CD\MP4
MP4
The PATH Instruction assumes that DOS, BASICA (GWBASIC) , and LOTUS are located in
subdirectories which bear their names. MP4BAS.BAT, MP4GW-BAT and MP4EXE.BAT may be
deleted if they do not apply.
8 The RS-232 Cable provided in the shipping kit of the MP4 should be connected between the Jl
connector on the rear of the MP4 and either the COM-1 or COM-2 connector on the rear of the
computer. The PRINTER/CMPTR switch on the rear of the MP4 should be pressed in to select the
computer (CMPTR) mode.
NOTE: If this switch is left out, in the PRINTER position, the software will appear to operate properly,
however the footswitch will have to be pressed in order to make the End of Test function keys operate
properly.
990-180
®
MICROPULL IV WIRE BOND PULL TESTER
CHAPTER 2: GETTING STARTED
2-5