Midea MOBA30U-12HN1-Q Service Manual page 261

Controller
3. MODE: Once pressing, running mode will be selected in the following sequence:
AUTO COOL DRY HEAT FAN
NOTE: No heating mode for cool only type unit.
4. SWING: Used to stop or start horizontal louver movement. The louver will swing up and down
automatically if push this button.
5. RESET (inner located): Once the recessed RESET button is pressed, all of the current settings will be
cancelled and the controller will return to the initial settings.
6. AIR DIRECTION: P Press this button to change the swing angle of the louver. The swing angle of the
louver is 6o for each press. When the louver swing at a certain angle which would affect the cooling and
heating effect of the air conditioner, it would automatically change the swing direction . No symbol will
appear in the display area when press this button. (Not applicable to units without this function).
7. LED: Press this button to clear the digit display in the air conditioner, press it again to activate it (Not
available for the units without LED display window).
8. FAN SPEED: Fan speed will be selected in following sequence once pressing this button:
AUTO LOW MED
HIGH
9. ON/OFF: For turning on or turning off the air conditioner
10. TIME ON: For time ON setting. Once pressing this button, the time will increase by 0.5 hour. When the
set time exceeds 10 hours, pressing the button will increase the time by 1 hour. Adjusting the figure to 0.00
will cancel time ON setting.
11.SLEEP: Press this button to go into the Energy-Saving operation mode. Press it again to cancel. This
function is only can be used on COOL, HEAT and AUTO mode and maintain the most comfortable
temperature for you.
12. TIME OFF: For time OFF setting. Once pressing this button, the time will increase by 0.5 hour. When the
set time exceeds 10 hours, pressing the button will increase the time by 1 hour.
Adjust the figure to 0.00 will cancel time ON setting.
13. LOCK (inner located): Push this button to lock in all the current settings, and the remote controller will
not accept any operation except that of the LOCK. Use the LOCK mode when you want to prevent settings
from being changed accidentally. Press the LOCK button again to cancel the LOCK function. A lock symbol
will appear on the remote controller display when the lock function is activated.
14. TURBO: Push this button to activate/cancel the Turbo function which enables the unit to reach the
preset temperature in the shortest time. On cooling mode, the unit will blow strong cooling air with super high
fan speed. On heating mode (applicable to the unit adopts PTC only), the PTC will bring fast heating
operation.
Electrical Control 257