Configurations - WEG CFW100-IOA Installation, Configuration And Operations Manual

I/O Expansion Modules
1. With the inverter powered down, remove its front
cover (Figure A1 on page
2. Fit the accessory to be installed as shown in
A1 on page
3. Power up the inverter.

5 CONFIGURATIONS

The CFW100-IOA connections must be done to the I/O
expansion connector according to
The pins of the accessory connector are presented in
Figure A2 on page
Table 1: Signals of the I/O expansion connector
Counter-
Connector Description
clockwise
6
7
8
Clockwise
9
10
The location of switch S1.1 to select the type of signal
at the analog input can be better viewed in
on page 15. To use the analog input with voltage
signal, you must set switch S1.1 = OFF and related
parameters, for current input you set S1.1 = ON, as per
Table 2 on page
6 | CFW100
14.
15.
GND Reference 0 V Not interconnected with PE.
AI1 Analog
Input 1
+ 10 V Reference
+ 10 V for
potentiometer
AO1 Analog
Output 1
GND Reference 0 V Not interconnected with PE.
7.
14).
Table 1 on page
Specifications
„
Isolated voltage input,
levels: (0 to 10) V or (0 to
20) mA or (4 to 20) mA.
„
Resolution: 10 bits.
„
Impedance: 100 kΩ for
voltage input and 500 Ω
for current input.
„
Programmable functions.
„
Maximum accepted
voltage: 30 Vdc.
„
Power supply: + 10 Vdc.
„
M a x i m u m c a p a c i t y :
50 mA.
„
Tolerance: ±5 %.
„
Insulated output, levels:
(0 to 10) V or (0 to 20) mA
or (4 to 20) mA.
„
Resolution: 10 bits.
„
Programmable functions.
„
R ≥ 10 kΩ (0 to 10 V) or
L
R ≤ 500 Ω (0 to 20 mA
L
/ 4 to 20 mA).
Figure
6.
Figure A2