Installing Aa Batteries - Garmin BC 40 Quick Start Manual

at the bottom of your license plate, you
must remove, rotate, and reattach the
camera clip. This allows you to properly
adjust the camera angle.
1
Using a Phillips screwdriver, fully
loosen the two camera clip screws
and remove the camera clip
the metal bracket.
2
Rotate the camera clip 180 degrees,
so the Garmin logo is facing right-
side-up.
3
Insert the two camera clip screws into
the holes labeled
BOTTOM OF PLATE
4
Tighten both screws.

Installing AA Batteries

The device operates on two AA batteries
(not included). For the best results, you
Quick Start Manual
should use lithium batteries, which provide
extended battery life and better
performance at low temperatures.
1
Rotate both battery covers
the front of the camera, and remove
, the battery covers.
from
2
Insert a AA battery into each end of
the camera, with the positive pole
facing outward.
3
On each battery cover, verify the
gasket
the groove.
.
4
For each battery cover, replace the
cover, press it tightly into the camera,
and rotate it toward the back of the
camera to lock it into place.
The camera is not water resistant if
the gaskets are not clean and properly
seated, and the covers are not
properly locked into place.
Installing the Camera in the Mount
1
Place one side of the camera into the
mount, with the lens facing outward.
toward
is clean and fully seated in
NOTICE
3