Installing Aa Batteries - Garmin BC 40 Quick Start Manual

Installing AA Batteries
The device operates on two 1.5 V AA
batteries (not included). For the best
results, you should use lithium
batteries, which provide extended
battery life and better performance at
low temperatures.
NOTICE
Do not use AA batteries with a
voltage specification higher than
1.5 V. Higher voltages will cause
permanent damage to the camera.
Do not use lithium-ion rechargeable
AA battery cells. Lithium-ion batteries
use a different technology than non-
rechargeable lithium batteries and
may permanently damage the
camera.
1
Rotate both battery covers G)
toward the front of the camera,
and remove the battery covers.
2
Insert a AA battery into each end
of the camera, with the positive
pole facing outward.
4
3
On each battery cover, verify the
gasket
®
is clean and fully
seated in the groove.
4
For each battery cover, place the
cover into the camera, press it
tightly into the camera, and rotate
it toward the back of the camera
to lock it into place.
NOTICE
The camera is not water resistant
if the gaskets are not clean and
properly seated, and the covers
are not properly locked into
place.
5
Verify each cover is fully sealed
and no part of either gasket is
protruding between the cover and
the camera.
✓
X
Installing the Camera in the
Mount
1
Place one side of the camera into
the mount, with the lens facing
outward.
Quick Start Manual