Getting Started - Garmin BC 40 Quick Start Manual

Getting Started

WARNING
See the Important Safety and Product
Information guide in the product box for
product warnings and other important
information.
Installing the Mount on Your
Vehicle
1
Remove the license plate screws from
the rear of your vehicle, and remove
the license plate, vanity frames, and
license plate covers.
NOTE: The camera mount is intended
to be installed onto the bare license
plate, and it is not compatible with
vanity frames or license plate covers.
2
Slide the metal bracket over the top or
bottom of the license plate.
The flat metal plate
slides behind the license plate.
NOTE: It is recommended to install
the camera above the license plate, if
possible. If there is not enough room
above the license plate on your
vehicle, you can configure the mount
for installation below the license plate
(page 2).
3
Hold the license plate and mount up to
the license plate area on your vehicle,
2
and slide the mount up or down to
align one set of mounting holes with
the holes in the license plate.
You should use the mounting position
that fits your vehicle and covers the
smallest portion of the license plate.
You must avoid covering any text or
numbers on the license plate. Some
jurisdictions prohibit covering any
portion of the license plate. It is your
responsibility to follow license plate
mounting regulations.
on the bracket
4
Insert the license plate screws through
the top of the license plate and mount,
and into the license plate mounting
holes on your vehicle.
In either orientation, the mounting
plate provides mounting holes at the
top and bottom of the license plate.
5
Fully tighten the license plate screws.
Installing the Camera at the Bottom of
Your License Plate
When the mount is installed on your
vehicle, the Garmin
clip must be right-side up. Out of the box,
the camera mount is assembled for
installing the camera at the top of your
license plate. When installing the camera
logo on the camera
®
Quick Start Manual