Advertisement
Recording
adjustments
and other operations
are
perlbrmed
from the recording
components.
Refer to the
operating
instructions
for those components.
(U.S.A.
model)
2
• \_len this unit is set in the standby mode, you calmot record
between other components connected to this unit.
• The setting of TONE CONTROL, VOLUME, "SP LEVEL"
(page 55) and the sound field pro_ams
does not affect recorded
material.
• A source connected to the MULTI CH INPUT jacks of this unit
cannot be recorded.
• Digital signals input to the DIGITAL INPUT jacks are not
output to the analog AUDIO OUT (L/R) jacks lbr recording.
You can only record analog signals.
• A given input source is not output on the same REC OUT
chmmel. (For example the signal input from VCR IN is not
output on VCR OUT.)
• Check the cop?Tight laws in your country to record from
records, CDs. radio, etc. Recording of copyrighted material may
infringe cop?Tight laws.
If you playback
a video source
that uses scrambled
or
encoded
signals
to prevent
it fi'om being
dubbed,
the
picture
itself may be disturbed
due to those signals.
1
Turn on the power of this unit and all
connected components.
2
Select the source component you want to
record from.
INPUT
or
•
Special considerations
when recording
DTS software
The DTS signal is a digital bitstream.
Attempting
to
digitally
record the DTS bitstream
will result in noise
being recorded.
Therefore,
if you want to use this unit to
record
sources
that have DTS signals recorded
on them,
the following
considerations
and adjustments
need to be
made.
For DVDs and CDs encoded
with DTS, when your player
is compatible
with the DTS format,
follow its operating
instructions
to make a setting so that the analog signal will
be output from the player.
Front panel
Remote
control
3
Start playback (or select a broadcast station)
on the source component.
4
Start recording on the recording component.
Y
Do a test recording belbre you start an actual recording.
47
Advertisement
