Recording A Source To Audio/Video Tape (Or Dubbing From A Tape To Another) - Yamaha RX-V2092 Owner's Manual

Notes on input mode selection
• To play back a source with the Dolby Digital (AC-3) decoded, set
the input mode to "AUTO".
• When you want to enjoy a source which has normal 2-channel
signals with a Dolby Pro Logic Surround program, select the
ANALOG mode.
• In the AUTO mode, there may be a case depending on some LD
players or DVD players that when you make a search on a source
encoded with the Dolby Digital (AC-3) during the play and then
the play is restored, sound output is interrupted for a moment
because the digital input signal is selected again.
48
RECORDING A SOURCE TO
AUDIO/VIDEO TAPE (OR DUBBING
FROM A TAPE TO ANOTHER)
NOTE: If you will use the remote control unit, be sure to use it with
the lid open.
1. Set the REC OUT selector to the SOURCE position.
Front panel
DVD/LD
TV/DBS
VCR 1
VCR 2
VIDEO AUX
2. Select the source you want to record.
Front panel
VCR 1 DVD/LD
TAPE (MD) TV/DBS
3. Play the source and increase the setting of the master VOLUME
control to confirm it. (For detailed information on tuning operations,
refer to page 50.)
Front panel
VOLUME
l6
20 l2
28
8
40 4
60 2
0
–dB
4. Set the tape deck, MD recorder or VCR used for recording to the
recording mode.
SOURCE
TAPE (MD)
TUNER
CD
PHONO
REC OUT
Remote control
DVD/LD
or
Remote control
MASTER VOLUME
or
MUTE