Yamaha RX-V2092 Owner's Manual page 19

C
TONE BYPASS switch
When this switch is pressed inward (ON), the input signal does
not pass through the tone (BASS and TREBLE) control circuitry
so that it is unaffected by the tone control circuitry. Use this
switch to obtain pure sound and to check the tone control
setting. Press this switch to release it outward (OFF) to use the
tone control circuitry.
D
BASS and TREBLE Controls
Adjust low and high frequency response respectively for the
main channels only.
E
BALANCE Control
Adjusts the left and right output volume to the Main Speakers to
compensate for sound imbalance caused by speaker positions
or listening room conditions.
F
Preset Station Number Selector Buttons
Select a preset station number (1 to 8).
G
REC OUT Selector
Selects the source to be recorded to a tape deck or
VCR independently of the setting of the input selector buttons.
However, when set to the SOURCE position, the setting of the
input selector buttons decides the source to be recorded to a
tape deck or VCR.
H
FM/AM Switch
Press this switch to switch the reception band to FM or AM.
I
MEMORY (MAN'L/AUTO FM) Button
When this button is pressed, the MEMORY indicator flashes for
about 5 seconds. During this period, select a desired preset
station number by pressing the corresponding preset station
number selector button to enter the displayed station into the
memory.
When this button is pressed and held for about 3 seconds, the
automatic preset tuning begins. (Refer to page 52 for details.)
J
TUNING DOWN/UP Button
Used for tuning. Press the "UP" side to tune in to higher
frequencies, and press the "DOWN" side to tune in to lower
frequencies.
K
EDIT Button
This button is used to exchange the places of two preset
stations with each other.
L
TUNING MODE (AUTO/MAN'L MONO) Switch
Press this switch to switch the tuning mode to automatic or
manual. To select the automatic tuning mode, press this switch
so that "AUTO TUNING" lights up on the display panel. To
select the manual tuning mode, press this switch so that "AUTO
TUNING" goes off.
M
DELAY/C/R/F/SWFR Switch
Whenever pressed, selects the item of changing delay time,
center speaker output level, rear speaker output level, front
effect speaker output level and subwoofer output level in turn.
* Depending on a mode of this unit, the number of selections is
reduced. For example, when the built-in digital sound field
processor (including the Dolby Pro Logic Decoder or the
Dolby Digital (AC-3) Decoder) is off, only the item for
changing subwoofer output level can be selected.
N
–/+ Button
Adjusts the level of item selected by pressing the
DELAY/C/R/F/SWFR switch. Moreover, performs setting
changes and adjustments for functions selected by pressing
the SET MENU switch.
O
SET MENU Switch
Whenever pressed, selects functions in the SET MENU mode.
15