G-U ELTRAL K35 Assembly And Operating Instructions Manual page 30

Assembly and operating instructions
ELTRAL K35 | ELTRAL K35 Synchro
Chain drive
Programming for synchronised operation (Synchro only)
ELTRAL K35 SYNCHRO is preset to synchronised operation, so programming is not necessary
except for adjusting the travel.
In the case of data loss, the drives must be synchronised anew (as described below).
The table below shows the DIP switch setting for running a Synchro drive in standalone mode
without synchronisation with another drive.
A test run should be carried out after programming.
Operation
Solo
Synchro
Switch shown in
„ON" position
Operation
without VAN
with VAN
Examples for DIP-switch settings:
Travel 300 / 500 / 800 mm Travel 200 / 400 / 700 mm Travel 100 / 300 / 600 mm
Operating mode
Solo
Operating mode
Synchro
Operating mode
Solo with VAN
Operating mode
Synchro with VAN*
* For drives with VAN only! Drives in operating mode 'Synchro' without VAN see DIP-switch settings 'Operating mode Synchro'
30
DIP-switch
3
ON
OFF
DIP-switch
4
OFF
ON
Operating mode Solo
Drive without VAN
Operating mode Synchro
Drive with VAN