Frico SWL Series Original Instructions Manual page 17

U I S INSTRUCTIONS
Symbol Function
The buttons on the remote control and the panel affect the same function.
When the unit is on, the set setpoint value on the three digits on the display.
The setpoint value can be set between 16 and 31°C.
The setpoint must not be set too high or low, as this means unnecessary energy
consumption and can cause comfort problems.
On/Off
The unit can be switched off (standby) or on with the button. The system is equipped
with a memory, which means that the settings will not be lost when the unit is turned off
or the power is switched off. The button is used to switch on or off, for short periods.
If the unit is to be switched off for a long time, the main switch must be switched off
or the power cord pulled out.
Comfort mode (automatic eco mode)
Depending on the set temperature, the fan convector selects fan speed depending on
the temperature in the room.
Cooling mode
In this mode, the convector dehumidifies and cools the surrounding environment.
The desired temperature can be set between 16 and 31°C. If this temperature is lower
than the room temperature, the fan convector will start after max. 3 minutes and cools,
the fan is active even if the setpoint value is reached.
Dehumidifying mode
In this mode, the convector dehumidifies the surrounding environment. This mode can
be used when the temperature is already comfortable, but there is a lot of moisture.
Neither heating nor cooling is used. The fan speed is set to minimum. In this mode it is
normal that the unit runs periodically.
Ventilation (not heating/cooling)
When this function is selected, neither heating, cooling nor dehumidification is used. It
is possible to select fan speed
Heating mode
In this mode, the convector heats the surrounding environment.
The desired temperature can be set between 16 and 31°C. If this temperature is higher
than the room temperature, the fan convector will start after max. 3 minutes and heats.
Comfort mode Night
When the fan convector is in cooling or heating mode, with this button it is possible to
access functions for sound level, energy saving and to control comfort mode Night. In
this mode, the fan is set to the lowest speed.
This function can be activated for the night.
• In cooling mode: the set temperature increases by 1°C after one hour and by a
further 1°C after two hours. After this, the set temperature does not change again
and after a further six hours the unit switches to standby mode.
• In heating mode: the set temperature decreases by 1°C after one hour and by a
further 1°C after two hours. After this, the set temperature does not change again
and after a further six hours the unit switches to standby mode.
This function is not available in dehumidifying mode, fan mode and comfort mode, and
can be cancelled at any time by pressing the button again.
If the timer function is turned on at the same time, the unit switches off when the set
time ends.
SLW
EN
59