Frico SWL Series Original Instructions Manual page 11

U I S INSTALLATION
1. Use the drilling template and mark where the mountings are to be located on the wall.
2. Make holes and insert the plugs (two per mounting). Install the two mountings. Adjust the
height using a spirit level before tightening the screws.
3. Tighten the screws.
4. Pull the mountings to the right, left, up and down in order to check that they are properly
tightened.
5. Mount the unit, check that it is secure on the mountings.
6. Check that the unit is straight.
A Plugs
B Mountings
1.
2.
6. Wrong
G
SLW
B
A
2.
5.
6. Correct, max. angle 1°
EN
A
53