Basic Operations - Yamaha RX-395RDS Owner's Manual

TO PLAY A SOURCE
1
Set to the "
2
Turn the power on.
3
Select the desired input source by using the input
selector buttons.
RX-495RDS
MONITOR
TAPE 2
COPY
RX-395, RX-395RDS
TAPE
MONITOR
* The name of the selected input source will appear on the
display.
* Note that pressing on each input selector button selects the
source which is connected to the corresponding input
terminals on the rear panel.
14

BASIC OPERATIONS

2
4
∞
" position.
POWER
TUNER CD
TAPE 1 AUX PHONO
TUNER CD
AUX PHONO
1, 6
3
7
4
Select the speakers to be used.
* If you use two speaker systems, press both the A and
B switches.
5
Play the source. (For detailed information on the
tuning operation, refer to page 17.)
6
Adjust to the desired output level.
7
If desired, adjust the BASS, TREBLE, BALANCE and
LOUDNESS controls, etc. (refer to page 16).
Notes
RX-495RDS only
If you select AUX, TUNER, CD or PHONO, be sure that
TAPE 1 and/or TAPE 2 are not being selected.
If you select TAPE 1 and TAPE 2 at the same time, the
result will be the sound from the tape deck 1.
For TAPE 1 and TAPE 2, whenever the button is pressed,
the corresponding input source is selected or canceled
alternately.
RX-395 and RX-395RDS only
Whenever the TAPE MONITOR is pressed, the tape deck
is selected or canceled alternately.
If both TAPE MONITOR and another input selector button
are selected, TAPE MONITOR takes priority of another
input selector button.
To turn off the power
Press the POWER switch again.
SPEAKERS
A B
ON ON
OFF OFF