Basic Operations; Basic Receiver Operations - Yamaha MCR-E410 Owner's Manual

Receiver/ cd player
Hide thumbs Also See for MCR-E410:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Follow the procedure below to select an input source and adjust the sound settings on the receiver.
PHONES
NATURAL SOUND STEREO RECEIVER RX-E410
DISPLAY
MEMORY
TIMER
TIME ADJ
BASS
TREBLE
STANDBY/ON
PHONES
BASS
TREBLE
STANDBY/ON
STANDBY/ON
(
)
1
5
FILE
/A-E
INPUT
/
INPUT
CD
TAPE/MD
1
Press STANDBY/ON to turn on the receiver.
The CD player also turns on by the system control
connection (see page 12). The front panel display
lights up.
y
This system has the auto-standby function (see page 34) which
automatically set to the system to the standby mode if you do not
operate the system for 30 minutes while the receiver is set to the
CD input mode.
2
Press one of the input selection keys or
INPUT
to select the desired input
/
source.

Basic Receiver Operations

PURE DIRECT
BALANCE
PURE DIRECT
AUTO/MAN'L
PRESET/BAND
PRESET/TUNING
VOLUME
TIMER
HOUR
MIN
INPUT
BALANCE
L
R
MIN
MAX
2
3
4
6
7
8
FILE
ENTER
/A-E
VOLUME
DISPLAY
VOLUME +/–
SLEEP
TUNER
BAND
AUX/TV
DOCK
Input
selection
keys
3
Start playback on the selected source
component or select a broadcast station.
For information on the disc playback, see page 21, and
for information on tuning, see page 26.
4
Press VOLUME +/– to adjust the volume to
the desired output level.
5
Rotate BASS, TREBLE, or BALANCE on the
front panel of the receiver to adjust the
following settings.
BASS: Adjusts the low frequency response.
TREBLE: Adjusts the high frequency response.
BALANCE: Adjusts the volume level of each left
and right speaker channel.
Pure Direct mode
The Pure Direct mode shuts down the tone control
circuitry, allowing you to enjoy pure high-fidelity sounds
from analog sources.
Press PURE DIRECT on the front panel of the
receiver to turn on the Pure Direct mode.
PURE DIRECT lights up, and the front panel display
automatically dims.
Notes
• While the Pure Direct mode is turned on, neither BASS,
TREBLE, nor BALANCE are available.
• If you carry out any operation while the Pure Direct mode is
turned on, the front panel display lights up briefly to
acknowledge the command and dims again.
To turn off the Pure Direct mode
Press PURE DIRECT again so that PURE DIRECT turns
off and the front panel display lights up.
To use headphones
Connect the headphones to the PHONES jack. You can
listen to the sound to be output from the speakers through
the headphones.
Basic Receiver Operations
19
En

Advertisement

Table of Contents
loading

Table of Contents