Listening To A Source; Basic Operations Listening To A Source - Yamaha RX-E100RDS Owner's Manual

RX-E100 BASIC OPERATIONS

Listening to a source

PHONES
NATURAL SOUND STEREO RECEIVER RX-E100
TIMER
STANTBY
DISPLAY MEMORY AUTO/MAN'L
TIME ADJ TIMER
STANDBY/ON PHONES
STANDBY/ON BASS
SLEEP
A
REP
D
PEAK
FREQ PS/PTY/RT/CT
MD
MD REC
MODE
1
Set the volume to "MIN" by turning VOLUME.
2
Turn on the power by pressing STANDBY/ON on
the front panel, or POWER on the remote control.
• RX-E100 can be used to turn on or put in standby mode
the system connected E100 series components depending
on their prior standby/on status.
3
Select the desired input source by turning INPUT so
that the source appears on the display.
• When you operate the component connected to the AUX
terminal, turn INPUT to select AUX.
E-8
TREBLE VOLUME
VOLUME
PRESET/BAND PRESET/TUNING
MIN MAX
HOUR PTY SELECT MIN INPUT
BASS TREBLE BALANCE
- + - +
L R
BALANCE INPUT
DISP
TIME
C
PROG
B
RNDM
E
TAPE
POWER
PTY SEEK
MODE START
VOLUME
VOLUME –/+
TAPE
CD
AUX
TUNER
PRESET
PTY SELECT TAPE REC
TAPE
START
DUBBING
4
Play the source. (Refer to the owner's manual
supplied with each selected component.)
5
Adjust the volume level by turning VOLUME on the
front panel or pressing VOLUME + on the remote
control.
6
If desired, adjust BASS, TREBLE, and BALANCE.
BASS: Turn this control clockwise to increase (or
counterclockwise to decrease) the low frequency
response.
TREBLE: Turn this control clockwise to increase (or
counterclockwise to decrease) the high frequency
response.
BALANCE: Adjust the balance of the output volume
from the left and right speakers to compensate for
sound imbalance caused by the speaker location or
listening room conditions
• These controls are only effective for the sound from the main
speakers.
When you use headphones
Connect the headphones to the PHONES jack. You can
listen to the sound from the main speakers through the
headphones.
When you have finished using this
unit
Press STANDBY/ON on the front panel again or
POWER on the remote control to set this unit to the
standby mode.
• The STANDBY indicator lights up.
Auto power off function
RX-E100 will be put automatically into the standby mode
under the following conditions:
• The component connected to RX-E100 is in stop mode
and not operated for 30 minutes.
• TUNER or AUX is not selected as an input source.