Yamaha RX-395RDS Owner's Manual

Yamaha RX-395RDS Owner's Manual

Natural sound stereo receiver

Advertisement

RX-495RDS/395/395RDS
Natural Sound Stereo Receiver
Récepteur stéréo "Son Naturel"
Natural Sound Stereoreceiver
Natural Sound Stereoreceiver
Sintonizzatore stereo a suono naturale
Receptor estéreo de Sonido Natural
Natural Sound Stereo Ontvanger
OWNER'S MANUAL
MODE D'EMPLOI
BEDIENUNGSANLEITUNG
BRUKSANVISNING
MANUALE DI ISTRUZIONI
MANUAL DE INSTRUCCIONES
GEBRUIKSAANWIJZING

Advertisement

Table of Contents
loading

Summary of Contents for Yamaha RX-395RDS

  • Page 1 RX-495RDS/395/395RDS Natural Sound Stereo Receiver Récepteur stéréo “Son Naturel” Natural Sound Stereoreceiver Natural Sound Stereoreceiver Sintonizzatore stereo a suono naturale Receptor estéreo de Sonido Natural Natural Sound Stereo Ontvanger OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING...
  • Page 2: Supplied Accessories

    Transmisor del control remoto Afstandbediening RX-495RDS Batteries (size AA, R6, UM-3) Piles (taille AA, R6, UM-3) Batterien (Größe AA, R6, UM-3) Batterier (storlek AA, R6, UM-3) Batterie (dimensioni AA, R6, UM-3) Pilas (tamaño AA, R6, UM-3) Batterijen (maat AA, R6, UM-3) RX-395, RX-395RDS...
  • Page 3: Table Of Contents

    Thank you for selecting this YAMAHA stereo receiver. FEATURES RX-495RDS 70W + 70W (8Ω) RMS Output Power, 0.04% THD, 20–20,000 Hz RX-395, RX-395RDS 45W + 45W (8Ω) RMS Output Power, 0.04% THD, 20–20,000 Hz High Dynamic Power, Low Impedance Drive Capability...
  • Page 4: Caution

    CAUTION : READ THIS BEFORE OPERATING YOUR UNIT. To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this unit in a cool, dry, clean place – away from windows, heat sources, sources of excessive vibration, dust, moisture and cold.
  • Page 5: Controls And Their Functions

    The remote control transmitter provided with this unit is designed to control all the most commonly used functions of the unit. If the CD player and tape deck connected to this unit are YAMAHA components designed for remote control compatibility, then this remote control transmitter will also control various functions of each component.
  • Page 6 NATURAL SOUND STEREO RECEIVER POWER RDS MODE/FREQ PTY SEEK MODE START PHONES SPEAKERS C D E F G RX-395, RX-395RDS : RX-395RDS only NATURAL SOUND STEREO RECEIVER POWER RDS MODE/FREQ PTY SEEK MODE START PHONES SPEAKERS C D E F G...
  • Page 7 Remote control sensor Receives signals from the remote control transmitter. RDS MODE/FREQ button RX-495RDS and RX-395RDS only When an RDS station is received, pressing this button changes the display mode into the PS mode, PTY mode, RT mode and/or CT mode (if the station employs those RDS data services), and frequency display in turn.
  • Page 8: Display Panel

    DISPLAY PANEL RX-495RDS, RX-395RDS AUTO STEREO 0 20 MEMO PS RT CT PTY HOLD EON NEWS INFO AFFAIRS SPORT SLEEP RX-395RDS RX-495RDS TAPE MON TAPE MON RX-395 PRESET STEREO 40 60 MEMORY TAPE MONITOR AUTO TUNING SLEEP...
  • Page 9 A/B/C/D/E button and one of the PRESET STATIONS buttons. RDS mode indicators RX-495RDS and RX-395RDS only The name(s) of RDS mode(s) employed by the currently received RDS station light(s) up. Illumination of the indicator on the head of a name shows that the corresponding RDS mode is now selected.
  • Page 10: Connections

    L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit. If you have YAMAHA components numbered as 1, 2, 3, etc. on the rear panel, connections can be made easily by making sure to connect the output (or input) terminals of each component to the same-numbered terminals of this unit.
  • Page 11 RX-395, RX-395RDS Turntable Tape deck UNBAL. TAPE PHONO TAPE Compact disc player Video cassette player, LD player, etc. Refer to “ABOUT THE ACCESSORY TERMINALS” on page 12. Speakers A Right Left SPEAKERS AC OUTLETS l00W MAX. TOTAL SWITCHED A OR B : 8 MIN./SPEAKER B : l6 MIN./SPEAKER...
  • Page 12: Connecting Speakers

    CONNECTING SPEAKERS Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and –...
  • Page 13: Antenna Connections

    ANTENNA CONNECTIONS Each antenna should be connected to the designated terminals correctly, referring to the following diagram. Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may result in improvement.
  • Page 14: Basic Operations

    BASIC OPERATIONS ” position. PHONO Notes RX-495RDS only PHONO RX-395 and RX-395RDS only To turn off the power Press the POWER switch again. 1, 6 Select the speakers to be used. SPEAKERS If you use two speaker systems, press both the A and B switches.
  • Page 15 Tape deck connected to the TAPE 2 terminals. the TAPE 1 terminals. 1, 4 RX-395, RX-395RDS Select the source to be recorded. PHONO When you select AUX, TUNER, CD or PHONO, make sure that TAPE MONITOR is not also selected.
  • Page 16: Selecting The Speaker System

    Selecting the SPEAKER system Because one or two speaker systems can be connected to this unit, the SPEAKERS switches allow you to select speaker system A or B, or both at once. SPEAKERS Adjusting the BALANCE control Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions.
  • Page 17: Tuning Operations

    • If you tune to an FM station manually, it is received in monaural mode automatically to increase the signal quality. • RX-495RDS and RX-395RDS only When tuned in to a station, the frequency of the received station is shown on the display. If an RDS station that employs PS data service is received, the frequency is then replaced by the station name.
  • Page 18: Preset Tuning

    Tune to a desired station. (Refer to the previous page for tuning procedure.) Select a desired group (A – E) of preset stations confirming it on the display. A/B/C/D/E RX-395 RX-495RDS, RX-395RDS PRESET MEMORY MAN'L/AUTO FM RX-395 RX-495RDS, RX-395RDS MEMORY Flashes on and off for about 5 seconds.
  • Page 19: To Recall A Preset Station

    To recall a preset station Select the group of preset stations. A/B/C/D/E RX-395 RX-495RDS, RX-395RDS PRESET Select the preset station number. PRESET STATIONS RX-395 RX-495RDS, RX-395RDS PRESET Notes A new setting can be programmed in place of the former one.
  • Page 20 FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 18. RX-495RDS and RX-395RDS only Only RDS stations can be stored by this function.
  • Page 21: Exchanging Preset Stations

    Recall the preset station on E1 (by following the method of “To recall a preset station” on page 19). EDIT RX-395 RX-495RDS, RX-395RDS MEMORY Flashes. Next, recall the preset station on A5 by following the same method with step 1.
  • Page 22: Receiving Rds Stations

    In areas where RDS broadcasts cannot be received, the RDS broadcast functions do not operate. (The procedures from page 22 to page 26 are not necesssary.) RX-495RDS and RX-395RDS only RDS (Radio Data System) is a data transmission system gradually being introduced by FM stations in many countries. Stations using this system transmit an inaudible stream of data in addition to the normal radio signal.
  • Page 23 Programs types in the PTY mode NEWS NEWS News: Short accounts of facts, events and publicly expressed views, reportage and actuality. AFFAIRS AFFAIRS Current affairs: Topical program expanding or enlarging upon the news, generally in different presentation style or concept, including documentary debate, or analysis.
  • Page 24: Changing The Rds Modes

    Changing the RDS modes When an RDS station is received, “PS”, “PTY”, “RT” and/or “CT” that correspond to the RDS data services employed by the station light up on the display. By pressing the RDS MODE/FREQ button once or more, you can change the display mode among the RDS modes employed by the received station in the order shown below.
  • Page 25 Calling a program of your desired program type from among preset RDS stations (PTY SEEK) By designating a program type, the unit automatically searches all preset stations for an RDS station which broadcasts a program of that program type. * There are 15 program types to classify RDS stations. For details, refer to page 23. Turn the unit into the PTY SEEK mode.
  • Page 26 Making this unit call a program of your desired program type automatically This function uses the EON (Enhanced Other Networks) data service on the RDS station network. By only selecting a desired program type (NEWS, INFO, AFFAIRS or SPORT), this unit automatically searches all preset RDS stations for a station that broadcasts a program of that program type in the background, and, if found, receives a program when its broadcast starts in place of the program now being received.
  • Page 27: Notes About The Remote Control Transmitter

    NOTES ABOUT THE REMOTE CONTROL TRANSMITTER Battery installation Battery replacement If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes Use only AA, R6, UM-3 batteries for replacement. Be sure the polarities are correct.
  • Page 28: Troubleshooting

    If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. SYMPTOM The unit fails to turn on when the POWER switch is pressed.
  • Page 29: Specifications

    Minimum RMS Output Power per Channel 8 ohms, 20 Hz to 20 kHz, 0.04% THD < > RX-495RDS ...70W+70W < > RX-395, RX-395RDS ...45W+45W Dynamic Power per Channel (by IHF Dynamic Headroom measuring method) < > RX-495RDS 8/6/4/2 ohms ...100/120/145/170W <...
  • Page 30 Power Consumption < > RX-495RDS ...120W < > RX-395, RX-395RDS ...145W AC Outlets 2 SWITCHED OUTLETS [Europe model]...100W max. total 1 SWITCHED OUTLET [U.K. model] ...100W max. total Dimensions (W x H x D) ...435 x 146 x 308.5 mm Weight <...
  • Page 31 YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VÄSTRA FRÖLUNDA, SWEDEN YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA...

This manual is also suitable for:

Rx-495rdsRx-395

Table of Contents