Yamaha RX-395RDS Owner's Manual page 20

AUTOMATIC PRESET TUNING
You can also make use of an automatic preset tuning function for FM stations only. By this function, this unit performs automatic
tuning and stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the
manual preset tuning method on page 18.
* RX-495RDS and RX-395RDS only
Only RDS stations can be stored by this function.
To store stations
1 FM/AM
2
MEMORY
MAN'L/AUTO FM
RX-395
MEMORY
RX-495RDS,RX-395RDS
MEMO
The automatic preset tuning begins from A1. Received
stations are programmed to A1, A2 ... A8 sequentially.
* If more than 8 stations are received, they are also
programmed to the preset station numbers on other groups
(B, C, D and E) in that order.
RX-395 only
If you want to store the first station received by the
automatic preset tuning to a desired preset station
number.
If, for example, you want to store the first received station to
C5, select "C5" by using the A/B/C/D/E button and the
PRESET STATIONS buttons after pressing the MEMORY
button in step 2 before the automatic preset tuning begins. The
first received station is stored to C5, and next stations to C6,
C7 ... sequentially.
If stations are stored up to E8, the automatic preset tuning is
finished automatically.
20
1
FM
Press and hold for
about 3 seconds.
Flashes.
AUTO TUNING
Flashes.
AUTO
2
When the automatic preset tuning is finished
The display shows the frequency of the last preset station.
Check the contents and the number of preset stations by
following the procedure of the section "To recall a preset
station" on page 19.
To recall a preset station
Simply follow the procedure of the section "To recall a preset
station" on page 19.
* RX-495RDS and RX-395RDS only
A recalled station is shown by the frequency or station name
on the display.
Notes
If no station is received by the automatic preset tuning
search, the search finishes after "NOTHING" flashes for
about 3 seconds on the display.
You can replace a preset station by another FM or AM
station manually by simply following the procedure of the
section "To store stations" on page 18.
RX-395 only
If the number of received stations is not enough to be stored
up to E8, the search will be finished automatically when it
reaches the highest frequency after searching through all
frequencies.
With this function, only FM stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 18.
RX-495RDS and RX-395RDS only
The automatic preset tuning search is performed through all
RDS network frequencies until stations are stored up to E8.
If the number of received stations is not enough to be stored
up to E8, the search will be finished automatically after
searching all frequencies.
With this function, only RDS stations with sufficient signal
strength are stored automatically. If the station you want to
program is weak in signal strength, tune to it in monaural
manually and program it by following the procedure of the
section "To store stations" on page 18.
* There may be a case that this function cannot receive a
station which could be received by the automatic tuning
method. This is because this function receives a large
volume of PI (Program Identification) data along with the
station.