Basic Operations - Yamaha RX-V890 Owner's Manual

To play a source
1
Set to the " " position.
34
40
50
2
Press the POWER switch
to turn on the power.
3
Select the desired input source by using the input selector
buttons. (For video sources, turn the video monitor ON.)
TAPE 2
MONITOR TAPE 1
VIDEO AUX
• The name of the selected input source will appear on the
display.
4
Select the front speakers to be used.
• If you use two front speaker systems, press both the A and
B switches.
18

BASIC OPERATIONS

2
4
VOLUME
l6
l8
l4
20 l2
24 l0
28 8
6
4
3
2
60
l
70
0
–dB
POWER
TUNER CD PHONO
VCR 2 VCR 1 LD/TV
SPEAKERS
A B
3
1,6
5
Play the source. (For detailed information on the tuning
operation, refer to page 21.)
6
Adjust to the desired output level.
20
24
28
34
40
50
60
70
If desired, adjust the BASS, TREBLE, BALANCE
controls, etc. (refer to page 20) and use the digital
sound field processor. (Refer to page 25.)
Notes on using the input selector buttons
• Note that pressing on each input selector button selects
the source which is connected to the corresponding input
terminals on the rear panel.
• To select the source connected to the VIDEO AUX
terminals on the front panel, press VIDEO AUX.
• The selection of TAPE 2 MONITOR cannot be canceled
by pressing another input selector button. To cancel it,
press TAPE 2 MONITOR again.
When you select a button other than TAPE 2 MONI-
TOR, make sure that TAPE 2 MONITOR is not
accidently selected as well.
• If you select the input selector button for a video source
without canceling the selection of TAPE 2 MONITOR,
the playback result will be the video image from the video
source and the sound from the audio tape.
• Once you play a video source, its video image will not be
interrupted even if the input selector button for an audio
source is selected.
To turn off the power
Press the POWER switch again.
VOLUME
l6
l8 l4
l2
l0
8
6
4
3
2
l
0
–dB