Yamaha RX-395RDS Owner's Manual page 15

TO RECORD A SOURCE TO TAPE
RX-495RDS
1
Select the source to be recorded.
TUNER
MONITOR
TAPE 2 TAPE 1
COPY
* To dub from tape to tape, refer to the "Notes" shown
below.
* When you select AUX, TUNER, CD or PHONO, make
sure that neither TAPE 1 nor TAPE 2 is also selected.
2
Play the source and then turn the VOLUME control up
to confirm the input source. (For detailed information
on the tuning operations, refer to the page 17.)
3
Begin recording on the tape deck.
4
To monitor the audio signals being recorded, press the
input selector button for the tape deck being used to
make the recording.
TUNER
MONITOR
TAPE 2 TAPE 1
COPY
Notes
VOLUME, BASS, TREBLE, BALANCE, LOUDNESS
controls and PURE DIRECT switch settings have no effect
on the material being recorded.
To dub from tape to tape, select TAPE 2 by pressing it.
Only the following method of dubbing can be made by using
this unit.
SOURCE
Tape deck connected to
the TAPE 2 terminals.
CD
AUX PHONO
CD
AUX PHONO
RECORDER
Tape deck connected to
the TAPE 1 terminals.
1, 4
RX-395, RX-395RDS
1
Select the source to be recorded.
TUNER
TAPE
MONITOR
* When you select AUX, TUNER, CD or PHONO, make
sure that TAPE MONITOR is not also selected.
2
Play the source and then turn the VOLUME control up
to confirm the input source. (For detailed information
on the tuning operations, refer to the page 17.)
3
Begin recording on the tape deck.
4
To monitor the audio signals being recorded, press the
TAPE MONITOR.
TUNER
TAPE
MONITOR
Note
VOLUME, BASS, TREBLE, BALANCE and LOUDNESS
control settings have no effect on the material being recorded.
2
CD
AUX PHONO
CD
AUX PHONO
15