Table of Contents
Advertisement
6
Installing the Switches
Parts needed for this procedure:
2
Switch
1
Decal
Procedure
1.
Use a knife to cut out the provided decal.
2.
Remove the knock-out by pressing on it from
inside the console.
3.
Install the decal between the switch holes.
1. Switches.
4.
Install the switches by pressing them into the
holes.
5.
Connect the wire harness to the switches.
Figure 11
2. Decal
7
Testing the Quick Attach
Front Frame
No Parts Required
Procedure
Test the machine to ensure that all controls and parts
are working as expected.
1.
Start the engine.
2.
Raise and lower the quick attach front frame
to ensure that all functions are working as
expected.
3.
Shut off the engine, engage the parking brake,
and remove the key from the ignition switch.
4.
Check for any leaks.
Note:
If there are any leaks or if the machine
is not performing properly, please review and
repeat the steps in this manual to ensure that
everything is connected properly.
g015952
8
Advertisement
Table of Contents
