Toro 30509 Installation Instructions Manual page 4

7. Disconnect the end yoke of the PTO shaft from
cutting deck gearbox shaft as follows.
•
Remove the roll pin from the end yoke and
the gearbox shaft
pin for re-use.
Figure 3
1. Gearbox
•
Loosen the 2 capscrews and locknuts
(Figure 3).
•
Slide the driveshaft end yoke from gearbox
shaft and tie them up to the frame for support.
8. Remove the 4 ring pins and clevis pins that
secure the deck lift chains to the adjustment
clevises on the cutting deck
9. Roll the cutting deck away from the machine.
(Figure 3). Retain the roll
2. PTO shaft end yoke
(Figure 1).
2
Mounting the Hydraulic
Tubes to the Front
Attachment Frame
Parts needed for this procedure:
1 Front attachment frame
1 Hydraulic tube, shorter
1 Hydraulic tube, longer
g015519
Procedure
1. Loosely install the shorter hydraulic tube to the
straight fitting on the valve
2. Loosely install the longer hydraulic tube to the
straight fitting on the manifold
1. Shorter hydraulic tube
2. Valve
4
(Figure 4).
(Figure 4).
Figure 4
3. Longer hydraulic tube
4. Manifold
g015534