Table of Contents
Advertisement
3.
Connect the rear end of the shorter hydraulic
tube to the tube on the machine
Figure 9
1. Shorter hydraulic tube
2. Valve
3. Longer hydraulic tube
4. Manifold
4.
Connect the rear end of the longer hydraulic
tube to the tube on the machine
5.
Tighten connections.
6.
Loosely secure the shorter hydraulic tube to the
adjacent tube, on the machine, with the smaller
tube clamp, plate, carriage screw, and flange
nut, as shown in
Figure
7.
Loosely secure the longer hydraulic tube to the
adjacent tube, on the machine, with the larger
tube clamp, plate, carriage screw, and flange
nut, as shown in
Figure
8.
Tighten the carriage screws and nuts.
(Figure
9).
g015521
5. Tube clamp, small
6. Tube clamp, large
7. Plate, small
8. Plate, large
(Figure
9).
9.
9.
5
Mounting the Driveshaft
No Parts Required
Procedure
1.
While aligning the driveshaft mounting holes
with the jack shaft hole, slide the driveshaft onto
the attachment jack shaft
1. Driveshaft
2.
Secure the driveshaft to the jack shaft with the
roll pin previously removed.
3.
Tighten the 2 driveshaft cap screws and
locknuts.
7
(Figure
10).
Figure 10
2. Jack shaft
g015499
Advertisement
Table of Contents
