Datamax H-Class H-6 Series Maintenance Manual page 17

Step
Ensure that no label stock is
installed in the printer then press
4
the ESC Key.
Proceed according to the kind of
media being calibrated:
Die-Cut Media -- Remove at least
six inches (15cm) of the
beginning label material from the
liner, and then install the media.
Adjust the Media Sensor (per the
table below) then press the ESC
5
Key.
Notched or Reflective Media --
Install media. Adjust the Media
Sensor (per the table below), and
then press the ESC Key.
Continuous Media -- Install
media. Position the Media
Sensor (per the table below).
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Adjustments and Maintenance
Action
REMOVE LABEL STOCK
Media Sensor Type
Die-cut Gap
Notched Gap
Reflective Reflective
Continuous Continuous
Displayed Message
PRESS ESC KEY
yyy
For die-cut media:
SCAN BACKING
PRESS ESC KEY
yyy
- or, for reflective media:
SCAN MARK
PRESS ESC KEY
yyy
Sensor 'Red Dot' Position
Centered under the label
Centered under the notch
Centered under the black mark
Centered under the label
2-3
Comment(s)
This sets the empty value -
where 'yyy' is a numerical
value representing the sensor
reading when no media is
installed.
This sets the gap (or mark)
value - where 'yyy' is a
numerical value representing
the sensor reading for the
TOF indicator.
Do not position a media
perforation over the sensor
when taking any sensor
reading.
If using media with small
notches or reflective marks,
ensure that the labels exit
straight from the printer.
Do not move the position of
the Media Sensor following
this step.