Datamax H-Class H-6 Series Maintenance Manual page 24

Step
Complete a table (see below)
using new measurements, as
follows:
(A) Raise the Printhead
Assembly. Place the label over
the Media Sensor, then lower
and latch the Printhead
Assembly. Record the sensor
reading as P.
(B) Raise the Printhead
Assembly. Place the liner,
11
notch, or mark over the Media
Sensor, then lower and latch
the Printhead Assembly.
Record the sensor reading as
G (or M).
(C) Raise the Printhead
Assembly. Remove all media
from the Media Sensor, then
lower and latch the Printhead
Assembly. Record the sensor
reading as E.
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
Adjustments and Maintenance
Action
TRAN SENSOR GAIN
Gain P
Number (paper)
08 185
Displayed Message
(0 - 31)
YYY
08
G or M
(gap or mark)
35
2-10
Comment(s)
Where YYY is a numerical
value representing the current
sensor reading.
The re-sampled values may
differ from those previously
recorded. This is normal; do
not readjust the Media
Sensor.
E
(empty)
11