Table of Contents
Advertisement
Operating manual
6
Mounting instructions
7
Installation
70
60
50
40
30
20
10
0
38
Germany - DIN 18251-1
70
60
50
40
30
20
10
0
Aug. Winkhaus GmbH & Co. KG ∙ Hessenweg 9 ∙ 48157 Münster ∙ T +49 251 4908 - 0 ∙ zutrittsorganisation@winkhaus.de ∙ www.winkhaus.de
ETB-IM
• Batteries are already inserted.
• Keep low-frequency and magnetic interfering sources, such as
• Do not subject the electronic door handle to mechanical stresses (knocks,
• Mount evenly on the door without tension or bends.
• If necessary, use the drill template provided for drilling.
• Only use the mounting material provided.
• To prevent the door handle or its individual parts from shaking loose, stiff,
Step 1: Door preparation: Ensure that Ø 8 mm drill holes are present on the
10
20
30
40
50
60
70
10
20
30
40
50
60
70
10
powerpacks, away.
shaking etc.) during assembly.
self-locking screws with suitable coating are used, which could make the
assembly more difficult.
Warning!
The assembly may only be carried out by qualified
personnel.
Note:
- The screws may only be tightened by hand. Do NOT
use a cordless screwdriver to tighten the screws!
- No liability will be accepted for destruction due to the
screws being tightened too tightly!
right and left of the lock follower (optional and only in the area of
the follower: Ø 9 mm or 10 mm) at a distance of 38 mm from centre
of hole to centre of hole (see 5.1 Definition of terms). Proceed in the
same way if the optional profile cylinder rosettes have been
ordered. Use a spirit level and the drill template from the Quick
Installation Guide.
Note!
The drill holes in your door in the lock follower area
or the profile cylinder hole often require reworking in
preparation for the ETB-IM assembly.
Note!
Illustration not to scale!
Advertisement
Table of Contents
