Connecting To A 10/100 Base T Interface - Motorola MVME761EXT Installation And Use Manual

Hardware Preparation and Installation

Connecting to a 10/100 Base T Interface

2
2-14
Connection to a 10/100 BaseT interface is done from the processor
module through the P2 Adapter to the MVME761EXT.
1. Turn all equipment power OFF and disconnect the power
cable from the AC power source.
2. Remove the chassis cover per the instructions in the
equipment user's manual.
3. If the chassis has a rear card cage, remove the filler panel(s)
from the appropriate card slot(s) at the rear of the chassis.
4. If necessary, move some of the other modules to allow space
for the cables connected to the P2 Adapter and the transition
module.
5. Attach the P2 Adapter (part number 01-W3203F0XC for the 3-
row version) to the backplane connector that is directly in line
with the P2 connector on the MVME460x processor module.
Note Be sure to orient pin 1 of the P2 Adapter connector with
pin 1 of the backplane connector.
6. Attach the 20 conductor cable (part number 30-W2365E01A)
to J10 on the P2 Adapter. Be sure to orient cable pin 1 with
connector pin 1.
7. Attach the 20 conductor cable to connector J7 on the
MVME761EXT transition module.
8. Insert the transition module into the chassis slot and tighten
the attaching screws.
Make sure there is good contact with the transverse
Note
mounting rails in order to minimize RF emissions.
Computer Group Literature Center Web Site