Connecting To An 8/16 Bit Single Ended Scsi Interface - Motorola MVME761EXT Installation And Use Manual

Hardware Preparation and Installation

Connecting to an 8/16 Bit Single Ended SCSI Interface

2
2-6
Connection to an 8/16-bit Single Ended SCSI interface is done from
the baseboard through the P2 Adapter to the MVME761EXT.
1. Turn all equipment power OFF and disconnect the power
cable from the AC power source.
2. Remove the chassis cover per the instructions in the
equipment user's manual.
3. If the chassis has a rear card cage, remove the filler panel(s)
from the appropriate card slot(s) at the rear of the chassis.
4. If necessary, move some of the other modules to allow space
for the cables connected to the P2 Adapter and the transition
module.
5. Install the jumper J1 (this jumper enables active SCSI
termination) on the header of the 5-row P2 Adapter, part
number 01-W3199F01A, if you are supporting SCSI devices.
6. Attach the P2 Adapter (part number 01-W3199F01A for the 5-
row version) to the backplane connector that directly in line
with the P2 connector on the MVME260x, or
MVME360x/MVME460x baseboard.
Note Be sure to orient pin 1 of the P2 Adapter connector with
pin 1 of the backplane connector.
7. Attach the 68 conductor cable (part number 30-W2364E01A)
to the P2 Adapter (J1). Be sure to orient cable pin 1 with
connector pin 1.
8. Attach the 68 conductor cable to connector J3 on the
MVME761EXT transition module.
Computer Group Literature Center Web Site