Table of Contents
Advertisement
BENDS AND TEES
All bends and Tees are fully welded on the inside and outside and come with a
locking band. Please note - Flue pipe bends are measured in degrees from the
vertical plane. Roof pitches are also measured in degrees, but from the
horizontal plane. Ie, a 30 degree flue bend will not follow a 30 degree roof
pitch.
135 DEGREE TEE
Used when exiting a wall at 45 degrees, allowing sweeping access to the
external part of the flue system. Tee Cap has to be ordered separately. Two
locking bands are included.
90 DEGREE TEE
When using the rear outlet on a stove. Tee Cap has to be ordered separately.
TEE CAP
Used with 90 Degree and 135 Degee Tees
Code:02-***-034
Code:02-***-035
Code:02-***-036
11
Hide quick links:
Advertisement
Table of Contents
