Resetting The Recorder; Hibernating A Tred30-16R - LogTag Recorders TRED30-16R Product User Manual

If an ALARM is present ( ) and the
button function is enabled, you will need to clear the alarm first
before you can stop the recorder. Please see
page 10 for more information on how to clear an alarm.

Resetting the Recorder

You can reset a recorder back to its original
Once re-set, recording can be started again as described in
Recorder on page 9.
Note that when performing this procedure all recordings and
statistics stored in the recorder are deleted and cannot be recovered.
Please ensure your data has been saved!
For this process to work, the recorder must be in the
Press and hold the button. The
l
When the symbol remains permanently on, release the
READY
l
button within 2 seconds. The recorder is now ready to be started
again.
The ability to reset a recorder is enabled or disabled in the
Options dialogue when configuring the TRED30-16R via LogTag
Analyzer (see Advanced Configuration Options

Hibernating a TRED30-16R

When hibernated, the recorder's power consumption falls to near zero
and the life of the battery approaches its shelf life (typically 5 or more
years).
This is useful for conserving battery life when the recorder is not used
for extended periods .
TRED30-16R recorders are placed into Hibernation using LogTag
Analyzer by clicking Hibernate on the LogTag menu.
The disply shows SLP for a few seconds, before turning itself off.
Page 14 of 16
Clear alarm by pressing STOP
Clearing an Alarm on
state.
READY
Starting the
state.
STOPPED
symbol will flash.
READY
Advanced
®
on page 6).
®
A hibernated recorder has no active display, however a button press will
wake the recorder up briefly. The display will show:
the low battery symbol
l
the text not rdY if the battery is OK, and the recorder can be re-
l
activated at a later point.
A hibernated recorder can be activated again by pressing the
buttons together continuously for a period of 6 seconds.
During this time the text not rdY appears and the
flashes. Release the buttons when the flashing stops.
You can re-activate a recorder with a low battery, however it is not
recommended to commence another trip.
Note: The real time clock is not running in a hibernated recorder and
must be set up if the recorder is manually activated. Therefore, the
procedure is automatically invoked (see
CLOCKADJ
Display Clock on page 8).
Once the clock has been set, the recorder is ready to be started again.
TRED30-16R Product User Guide, Revision 1.3, copyright © 2004-2016,
if the battery requires replacing.
READY
Adjusting the
®
LogTag Recorders . All rights reserved.
and
icon